SERVICE TRAINING CLASSES
News about Gas Absorption products, about ROBUR Corporation and about HVAC market
01.17.2011
Service Training classes
Robur Corporation would like to invite you to attend a Service Training class on Robur’s latest absorption cooling and heating technology scheduled for April 12, April 13 and April 14, 2011.
This training will be held at the Robur Distribution Center, 827 East Franklin Street, Evansville, IN 47711.
Service training will be on the following models:
- ACF60 ST (Standard), HT (Comfort Conditioning for High Ambient Areas), TK (Process Applications), LB (Medium Temperature Refrigeration), HR (Heat Recovery) models;
- AYF60-119/2 and AYF60-119/4: Chiller Heater Models – Two & Four Pipe;
- GAHP-A (High Efficiency Heat Only Heat Pump);
- GAHP-AR (Reversible Cycle Cooling and Heating, Heat Pump);
- GAHP-W and GAHP-W-LB (Ground Source Heat Pump, Heating and Cooling).
In addition, the class will include installation and programming for the optional DDC Control, and installation procedures for the Robur software used to update the unit’s micro processor (students may bring their own laptop computer).
Hands on training, each desk (two students) will have a working Microprocessor board and DDC Controller. For additional hands on training we will use the GAHP-AR (Reversible Cycle Heat Pump).
The class agenda will be as follows:
-
Day 1 April 12, 2011
- 8:00AM Start
- Overview of the ROBUR Equipment
- Cycle of Operation (All Models)
- Break
- Installation (All Models)
- 12:00 Lunch
- Continue Installation
- Break
- Explanation of Components (All Models)
- 4:00PM Dismissal
-
Day 2 April 13, 2011
- 8:00AM Start
- Explanation of Components (All Models)
- Break
- Error Codes and Electrical Trouble Shooting (All Models)
- 12:00 Lunch
- Error Codes and Electrical Trouble Shooting
- Break
- Error Codes and Electrical Trouble Shooting
- 4:00PM Dismissal
-
Day 3 April 14, 2011
- 8:00AM Start
- Maintenance procedures (All Models)
- Break
- Replacing the S60 board (Microprocessor) and set up procedures
- 12:00 Lunch
- Procedure for updating the firmware on the S60 board
- Break
- DDC Controller
- Certification Test
- Wrap up and presentation of certificates
- 4:00PM Dismissal
The cost will be $350.00 per person and will include lunch and manuals. Payment must be sent with the Registration Form.
We foresee a great deal of interest and participation in this training session. We suggest you sign up early. Please complete the attached registration form and return by March 28, 2011. You may send your registration to us at:
827 East Franklin Street
Evansville, Indiana 47711
Attn: Willis Schroader
Fax to: 812-422-5117 Attn: Willis Schroader
RETURN FORM NO LATER THAN MARCH 28, 2011
Share